Winbond 25q32 programmator3/10/2023 1.13 and 1.18 seem to read the chip but 1.30 only says that it can not detect the chip. Still the CH341A Programmer software can not detect the chip (I’ve tried version 1.13, 1.18, 1.30). So from what I see, everything looks fine. The clip is aligned correctly (I’ve tested that every pin of the chip is connected to the correct pins on the CH341A and that there are no non-connected pins etc.). So I am now trying to flash a bios file onto the chip using my CH341A Programmer and a SOIC test clip. The chip can not be detected, reading goes to 100% and shows empty, writing give a time out. The connections should be correct according to pinouts I’ve found via Google. I have tried using the JSPI1 pins of the mainboard in combination with the CH341A but have not succeeded. I guess that’s what happens when the BIOS chip is empty? The board can be turned on (LEDs lighting up etc.) but obviously it does not display anything on screen or boot up. The Update erased the chip and then the PC shut off completely without flashing anything. I have a bricked Mainboard due to a bad Bios Update.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |